In that case, If you need a small repair or replacement of components of the car, often much cheaper and more, what is not less important, faster, will do everything yourself. For example, to replace the lash does not need a set of special tools and do not need an auto mechanic skills. To do this, go to Internet auto parts store MAKAVTO, checkout, receive the item and to carve out a little time for self replacement.
Lifters are an important part of the foreign car engine, whereby wear of the system is significantly reduced. They absorb the "thermal gap", thereby not allowing the engine to overheat.
The most frequent causes of failure
- Most often, these parts fail due to clogged channels. channels, in turn, can become clogged due to the use of poor-quality oil or due to illiteracy vehicle repair.
- In the event that the car for a long time was not in operation, the oil can flow out of the lash. To eliminate the fault should be done engine washing, fill with oil of good quality and give him a run for 10-15 minutes.
- Gidrokompensator It has a lifespan, therefore it is necessary to periodically change. To do this, buy parts online store and replace them with their own, not overpaying money for the services of expensive garages and without spending too much time.
As a self-lifters to replace foreign car?
In that case, if one or more lifters are out of order, it directly while the engine is running you can hear a characteristic noise, reminiscent of the sound of valves. Usually, expansion joints installed directly over the set in order to avoid emergency breakdown. For independent replacement should adhere to the following simple algorithm of actions:
- valve cover, air filter and timing belt cover removed, then need to be cleaned from plaque candle wells and testing of engine oil.
- Push lever and special rockers dismantled, then you must remove the old hydraulic lifters. If they are dents or scratches, they must necessarily be replaced by new. For disassembly of defective or old joints, you can use a special magnet, however, the procedure can be implemented even without the presence of the instrument.
- Next, a set of new lash, after which the rockers are mounted back. Before installing the valve cover in place, you need to put on her new gasket.
- Bolts and fastening the cover elements are also set back using a torque wrench.
To replace this element takes about one and a half hours of free time. After completing the replacement of parts is necessary to bring the oil level to normal, and the engine allowed to run for a few minutes.
