10 the most common problems of washing machines

Washing machines are often subject to minor faults and a little less strong breakdowns. In the second case the owners are turning to a service center for repair, and in the first looking for the cause and try to fix them on their own. In this article we will talk about the ten most common faults in the washing machine and how to fix them.

Washing machine pours water

From the washing machine water is poured? probably, clogged filter, to be clear. If, despite regular cleaning it clogs, this indicates, that between the drum and rubber seal is too big a gap allowing the laces and other small leak. To prevent this, it is recommended to use special bags for small items lockable zipper.

note! Before placing in the drum, check for the presence of pockets of coins, lighters, briefs, business cards and other small items. Thus you will prevent filter blockage.

Причиной вытекания воды из люка стиралки может быть также неисправный замок. В этом случае вам стоит приобрести новый замок для стиральной машины, сделать это можно тут https://master-plus.com.ua/stiralnaya/zamki_jxbrto/, and to conduct its replacement. Make it is not difficult, how to replace the lock locking the door of the washing machine, see the video below.

https://www.youtube.com/watch?v=ZbuoqMj3YZM

Washing machine does not receive water, what is the reason?

Usually, This is because the hose, which supplies thereto water, perverted, clamped or separated, during spinning washing machine could move a little and pull it out.

Not a closed door, is another reason, on which electronics does not start pouring water into the drum. In this case, you want to check wiring, and if it is a whole, the blame for this is spoiled by a solenoid valve, which will only be able to change a specialist in the service center.

excessive noise

excessive noise, usually, It appears when untwisted bolts holding drum. In the case where the bolts are tightened, and equipment on a level surface and continues to make noise, cause is faulty bearings or dampers requiring replacement.

Clothes stained with grease

If, after the wash cycle, clothes stained with grease, the reason for this is a damaged drum. The drum itself breaks for two reasons::

• damaged seal – passes water into the bearing;
• Overload clothes during washing.

Depending on the damage required replacement of the bearing or seal.

Washing machine does not command

If your washing machine does not respond or passes some stages of the washing cycle, the damaged programmer, which unfortunately need to be replaced.

Under the drum object has fallen

This problem relates to the top-loading models. Often under the drum fall hair elastics, scissors and toothbrushes. In most cases you can get a special opening a small window located in the drum, if there is no such, You have to contact the service center.

Short circuit, automatic shutdown

If the washing machine knocks fuses, probably, неисправен нагреватель. A stone plaque to form over the years to tene complicates the transfer of heat to water, therefore leads to its combustion. As a result, it required to carry out replacement. Ten can be checked with an ohmmeter, show resistance serviceable 25-35 ohm. При проведении измерений тен должен быть отключен от проводки, otherwise it will display the wrong data.

The drum does not rotate

First, you need to check on the performance of the engine. If it is correct to draw attention to the belt, it must be sufficiently tightened to rotate the drum. Anyone with time the belt may stretch, as a result it becomes relaxed and not spinning the reels. With belt replacement can cope at home.

stone plaque

On the internal elements can often be seen stone plaque, which is very harmful to moving parts. Numerous studies have shown, that although the temperature at which the washing is carried out, Calgon reduces the number of stone deposits, and thus extends the life of machinery.

unpleasant smell

If the laundry after washing does not smell but rather stinks, the reason for this is contaminated powder dispenser. Soaked powder dispenser is located in a very bad smell. That in this connection, to do? It is recommended to periodically clean the dispenser.

How to avoid damage to the washing machine?

1. The washing machine must be connected to a grounded outlet.
2. Once a month, you should run the cycle without clothes, wherein instead of citric acid powder to strew, and the temperature exhibit 95º Celsius.
3. Filter and dispenser of the powder should be cleaned at least once a month.
4. Not in any case you can not put more laundry than recommended by the manufacturer.
5. After completion of the washing door must be ajar, to excess moisture to evaporate. Thus inside will not form an unpleasant odor.