There comes a time, when each holder iron horse face problems of wear of different parts of the car. And sometimes it is not only depends on driving style and road conditions. Sometimes it comes from the, that some part has exhausted its resource. In such cases, a trip to a service station is inevitable.. But what to do, if for one reason or another it is not possible to do? If the car is present the "extra" buzz or rattle wheel bearings, The fastest way need to be replaced. How do we tell you and in this manual. 
Replacement of bearings wheel hubs Skoda Octavia II
First you need to purchase a set of hub bearings of wheels of the car, I recommend the front bearing hub buy online store MIC company Bearing.
Replacing the front wheel bearings:
- 1. Raise the car, remove the wheel, Remove the brake caliper and the brake disk.
- 2. Remove protection (For that the screws on the inside of the hub).
- 3. Remove the tie rod (thus it is necessary to unscrew the nut wrench, on the other hand to hold the hexagon).
- 4. Unscrew the bolts from the spherical support lever (Depending on the model, three or four bolts) and using puller remove SHRUS (grenade).
- 5. Remove the hub and thoroughly clean the groove for the new bearing.
Warning - Do not damage the ABS sensor (white arrow).
Install in reverse order. After installing the caliper repeatedly press the brake pedal, in order to check clearances (adjustment) brake disc.
note! In any case should not be removed from the lift car!
When tightening the hub axle nut effort should be 300 N.m, then the nut to relax for half a turn (1/2 about) and again tighten, but with effort 50 N.m.
Replacement of rear hub bearings:
- 1. Without lifting a car, "Release" wheel bolts and mounting hub.
- 2. Remove the brake drum and carefully remove the connector from the wheel sensor (for this it is necessary to squeeze the fingers).
- 3. "Hexagons" unscrew a bolt of fastening of the gauge and remove the sensor itself.
- 4. Unscrew and remove the hub bolt.
- 5. Remove the rear wheel hub with bearing.
Installation is in the reverse order, and pay attention to the installation of the sensor - it should be easy to enter into his seat. In no case can not embed the sensor.
