Parquet board, despite the relatively high cost, does not lose its popularity and demand, since natural wood is used, therefore a safe coating is still valued today. It is worth noting not only the beauty and exquisite appearance, but also the texture of the coating, as well as a unique relief, long life, which is achieved thanks to the top decorative layer, cycled.
Lacquer or oil finish?
The parquet board is varnished or oiled, to protect the surface from damage.
Arbofari specialists consider, that varnish is more practical, since the board can be in active use without sanding until 10 years old, when the oil coating will have to be restored every 2 of the year.
The varnish is applied to the surface in several stages., after the selected wood goes through the stage of puttying and priming, as well as cycling. For a long service life, apply 7 layers of varnish. To consolidate the effect, the plates are dried and processed under ultraviolet rays..
An oil coating is applied to emphasize the naturalness and beauty of wood, the shade of the selected board becomes clearer and deeper, while the flooring has a beautiful reflection. Oil coating is considered environmentally friendly, it perfectly impregnates the wood and allows it to breathe. On the Arbofari website, you can view the assortment with this coverage.
What board thickness to choose?
You can buy a parquet board with a thickness of 7 mm 26 mm. But it is better to give preference to thicker dies, because they:
- more resistant to mechanical damage;
- achieve the desired thermal and sound insulation;
- you can lay the selected board directly on the logs or concrete screed.
Choosing flooring for an apartment, it is worth giving preference to dies with a thickness - 14 mm, which have a decorative layer in 4 mm, which allows restoration 2-3 times and enjoy natural wood for a long period of time
Floor covering from 20 mm it is preferable to lay in crowded places, where a constant active load on the floor is expected.
It is worth noting, that the longer the bar, the better it dampens vibrations, that occur when walking.
What is the lock system?
The quality and density of the parquet board connection directly depends on the locks, which are installed on it.. Therefore, in order for the coating to look like a single whole, it is necessary to give preference to UniCinic or T-Clock locks..
If the parquet board will be laid on the screed, preference should be given to thicker dies, which can be installed without backing. It is also worth focusing on the coating of wood, because care depends on it., as well as the number of cycles.
According to information: https://arbofari.ua/ru/