Gypsum boards are very simple in construction material processing. they are light, durable, tough, and at the same time they are easy to cut and mount. So it is often used during finishing in new homes or apartments.
Dry mounting system simplifies many finishing works inside the building, It is making it easier, cheaper and faster in the implementation of. Easy installation battens, easy and accurate cutting of plates, составляющих обшивку и легкая отделка, these are the main advantages of this solution. Easy installation allows you to divide the space quickly, изменить объем помещения или придать некоторым элементам интерьера привлекательный современный внешний вид. Simple and quick installation, более низкая затрата на оплату труда, and the time, required for the manufacture and installation of partitions, much less than using other materials, It minimizes the wet work (plaster, masonry), typical of traditional construction work.
Mounting frame for the cladding of plasterboard
The first step is to define the plane, to be obtained. To this end, on the floor, стенах и потолке рисуется контур будущих профилей. Further, the guide profile mounted on the perimeter, whereupon are mounted vertically rack profiles for gypsum plasterboard, которые образуют собой решетку, subsequently using metal screws fastened plasterboards, buy screws GC, you can shop online Torgplit. For detailed instructions on how to make the frame, see the video on this article.
https://youtu.be/Ppx2wQnfxvI
Installation of gypsum boards
Plasterboards composed of gypsum core, on both sides draped cardboard, whose task is to impart the smoothness of the plate and to ensure adequate strength. Currently available gypsum boards usually have a width 120 cm, length of 2 to 3 m, standard thickness – 12,5 mm. It is worth remembering, that the boards should be attached "height", that is, the long side vertically, and in wet areas (bathroom, restroom) They should be used green plate (with impregnation against moisture). Прикручивая плиты к каркасу саморезами нужно заботится о том, that the screw heads are recessed into the drywall carefully. How to fasten drywall to profile, refer to the video for this article.
Filling of plasterboard joints
For filling joints between boards applied spackling mixture. On the market are two types of such materials:
- Caulking Caulking using reinforcing tape. В первом случае шпаклевочный гипс применяется с лентами из стекловолокна или бумаги.
- Putty composition for grout without the need for reinforcing strips. costs, but, Mark, that this solution is only recommended for slabs with pre-formed edges and when the design has good stiffness.
As drywall putty joints, see the video below.
https://youtu.be/nCHG0OFLtzU
