motorcycle Parts, instead of, to ride on its wheels, shall be carried 4-wheeled friend. For transport on a trailer or within a vehicle it must be securely fastened, какие стяжные ремни в этом случае стоит использовать и как.
What use coupling belts?
Selection of appropriate transport belt is very important. It would be better, which tightening belt to buy Motorcycle transport?
First of all, pay attention to the choice of the correct length and width. it makes no sense to use a belt width for transporting motorcycles more 50 mm or more in length 4 m, as the excess of these values will complicate locking. It is also forbidden to bend the other 20-millimeter straps, потому что последствия их разрыва во время транспортировки – особенно на прицепе – могут быть трагическими не только для мотоцикла, but also for other road users. How standard, cost to buy tie straps width 25 mm that can withstand the weight 500-1000 kg. However, they can sometimes break, therefore, the most popular version has a width 30-50 mm, eg 38 mm .
Ремни должны быть хорошего качества – изготовлены из прочных материалов, with a suitable mounting system. It is recommended to use a model with a closed seizure without open hooks on the end that can jump over large potholes . Professional tightening belts for transporting motorcycles also have additional sleeve, which protect the bike from damage caused by the movement of the belt.
How to fix a motorcycle for transportation?
Even the coolest trailer or belts will not guarantee successful transportation, if we fail to properly secure the motorcycle . Below we describe, how to do it.
We need four tie belt for transportation, two of which will hold a two-wheeled machine upright, while the other two will prevent it from moving back and forth.
The distance between the fastening elements should be as wide as possible, so that the belt ends are far from the motorcycle, which will make it much more stable. On a motorcycle fasten the strap to the permanent elements.
Мотоцикл должен стоять прямо – если наклоняется, loosen the straps and install vertical cable. Carefully pull cables, without excessive sagging, permissible inclination in the direction of the motorcycle is about 5 cm.
Защищаем мотоцикл от движения вперед и назад – крепим ремень параллельно ему, usually, on the rear wheel. At the end we check the tension of all belts and hit the road. After a few kilometers is necessary to stop and check, everything is okay.
Tips!
- Never attach the bike to the moving parts of the vehicle or trailer.
- Do not use belts with open hooks.
- Do not attach the straps so, to touch the sharp edges.
- Do not block brake.
- Do not use belts, which may be damaged or have visible defects.
How to transport a motorcycle, and its installation on the trailer are not complicated, if we follow the rules. note! Careful driving guarantee security for your motorcycle, and for other road users . If you have no experience in motorcycle transportation, ask someone, who knows, how to do it. Дополнительную информацию на вопрос “Как зафиксировать мотоцикл при перевозке” смотрите в видео к этой статье.
